The 1000W wind turbine is supplied as a complete kit. The only other things you
will need to install this unit are: a set of deep cycle batteries (which we can
supply, if required), a dump load controller to prevent overcharging of the
batteries, and cement for the foundations.
The following items make up the 1000W wind turbine kit ...............
  • 3 section tower, labelled upper, middle and lower
    (each 2m long):
  • Tail-section  including 6 bolts for fin;
  • 3 blades;
  • Footing for the tower, including pivot
    bolt;
  • Wind turbine body including cabling
    and bolt for tail;
  • Blade hub with 6 bolts and
    restraining pieces
  • Fin;
  • A nose cone;
  • 3 catenary wire pieces for stays;
  • 6 U bolts to secure catenary wire;
  • 2 round spikes for securing footing;
  • 3 angled pegs to secure catenary
    wire to ground;
  • 3 turnbuckles with hook and eye
    ends;
  • Rectifier/regulator unit
  • A 48v power inverter
    (1kw)
BOX 1
BOX 2
BOX 3
Tel - 01269 850607
WELCOME TO BOB STRATFORD
ALTERNATIVE ENERGY
1kw Wind turbine kit
(48v)
Counter
Search the site
Search the web
Rated power
1kw
Max power
1.5w
Output DC voltage
48v
Start wind speed
3m/s
Rated wind speed
9m/s
Max wind speed
40m/s
Cut out wind speed
None
Blade pitch control
None, fixed pitch
Overspeed protection
Auto furl
Gearbox
None, direct drive
Temperature range
-40 to +60 Deg.C (-40 to +140 Deg.F)
Rotor diameter
3.10m
Rotor speed
400rpm
Blade
3
Blade material
Reinforced fibre glass
Weight of blade
15kg
Height of tower
6.0m
Weight of tower
60kg
Diameter of tower pipe
114mm
Weight of turbine
42kg
Generator
3 phase permanent magnet alternator
Sine Inverter power output
AC110/220v, 50HZ/60HZ
Weight
180kg
Packing for shipping
One plywood case and two cartons...
93x76x34.5cm 210x34x22cm 48x48x28cm